Cam follower / tappet, standard size

Not for PI / hydraulic tappet models produced between 2003 and 2006

 2 in stock

 17045860 GU17045860 17 04 58 60
 1704 5860 1704.5860 17.04.58.60

Inlet Valve

41mm diameter. Also known as Guzzi ref. 29036050

 2 in stock

 13036000 GU13036000 13 03 60 00
 1303 6000 1303.6000 13.03.60.00

Little end or con rod bush

Also known as Guzzi ref. 91112128, 91112124, 91112127, 91112123, 91112122. Note that little end bushes may need reaming to suit your conrod and gudgeon pin

 2 in stock

 91112128 GU91112128 91 11 21 28
 9111 2128 9111.2128 91.11.21.28

Tappet adjuster screw

See GEA92508 for adjuster nut

 2 in stock

 12034001 GU12034001 12 03 40 01
 1203 4001 1203.4001 12.03.40.01

Head gasket for models with round pushrod tunnels

 2 in stock

 13022001 GU13022001 13 02 20 01
 1302 2001 1302.2001 13.02.20.01

Pair of black tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Pair of chrome tubular rocker cover protector bars for round and square barrel engines, these will protect barrels and rocker cover in the unfortunate event of your bike being dropped

These head protectors bolt to the head using existing rocker cover bolts, they won't fit models with fairing lowers that wrap around the cylinders (e.g. Spada) without modification. To modify simply reduce the length of the rear section of the bar to stop short of the fairing and insert the supplied grommet. These bars are supplied with a plastic grommet for each end, this will need chamfering or leaving off on round head models with bolt on rocker cover breather pipes, e.g. T3. These bars will not fit on a T3 or other model with knee pads

 1 in stock

Polished aluminium distributor cover for models with points or electronic ignition. Alternative for plastic cover ENA14420

See SSA05025 for the screws which secure this dizzie cap

 1 in stock

14715420-z 14715420 GU14715420 14 71 54 20
 1471 5420 1471.5420 14.71.54.20

Dizzie bearing

 1 in stock

Crankshaft Sludge Trap Plug

 1 in stock

 12065400 GU12065400 12 06 54 00
 1206 5400 1206.5400 12.06.54.00